Error Message Displayed — Connection or Power Issue

Was bedeutet Error Message ?

An error message appeared on the scan tool during connection or operation. This usually points to a problem with the scan tool's connection to the vehicle or its power supply.

• Ignition key not in the correct position (ON, not ACCESSORIES).
• DLC cable is not securely connected to the vehicle's data link connector or the scan tool.
• Damaged pins or debris in the vehicle's DLC.
• Broken wire in the DLC cable.
• Blown fuse in the vehicle's fuse box.
• Poor ground connection for the vehicle's control module.
• Low vehicle battery voltage.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Ensure the ignition key is in the ON position (engine off).

2. 2

   Verify the DLC cable is firmly plugged into both the vehicle and the scan tool.

3. 3

   Inspect the vehicle's DLC for bent or broken pins and clean any debris.

4. 4

   Check vehicle fuses related to the OBD-II system and replace if necessary.

5. 5

   Confirm the vehicle's control module has a good ground connection.

6. 6

   Check vehicle battery voltage; it should be at least 8.0V with the key on, engine off.