Trapped — Automower is stuck or caught on an obstacle

Was bedeutet Trapped ?

This message indicates that the Automower has encountered an obstacle and become stuck or trapped. It might also be related to loose body screws or issues with collision sensors.

• Automower has got caught or become trapped by an obstacle.
• One or both rear screws on the body are not tightened correctly.
• Magnet in the collision sensor pillar is loose, twisted, or missing.
• Collision sensor card or its cabling is defective.

Klicken Sie auf Schritte, um Ihren Fortschritt zu verfolgen.

1. 1

   Free the Automower from where it is caught and remove any obstacles.

2. 2

   Check the rear section of the body to ensure both rear screws are tightened correctly.

3. 3

   Lift the body from the rear to feel if it is secured; tighten screws if loose.

4. 4

   Check collision sensors via Tools - Test - Sensors (shortcut 5-2-5) to verify magnets and cabling.

5. 5

   If the mower indicates a collision without actual contact, inspect sensor magnets and cabling for defects.