Green LED single flash — Break in the loop signal

¿Qué significa Green LED single flash ?

The green LED on the charging station is flashing once per second, indicating a break in the boundary loop wire and no signal is available.

• A break in the boundary loop wire.
• Poor connection to the charging station's circuit card.

Haga clic en los pasos para seguir su progreso.

1. 1

   Disconnect all cables from the charging station and measure the resistance in the loop wire using a multimeter. Correct resistance should be between 0-20 Ohm.

2. 2

   If the value is >20 Ohm, locate and repair the break in the loop. Use an appropriate break detector or cut the area in half using the guide wire to find the break more quickly.

3. 3

   If the value is <20 Ohm, check all connections to the charging station.

4. 4

   If the fault cannot be corrected, consider replacing the circuit card in the charging station (see section 5.3 on page 89).