Indesit Splendide Laundry Centers

This error indicates a short circuit in the motor control component (triac). This can prevent the motor from operating correctly and may be linked to internal motor or module problems.

This error suggests that the motor might be obstructed, preventing it from turning, or that its speed sensor (tacho) is not connected or working correctly. The drum may not rotate.

This indicates an issue with the NTC thermistor, which measures the water temperature. It might be a short circuit or an open circuit, leading to incorrect temperature readings.

This error means the pressure switch, which detects the water level, is reporting that the tub is empty, even if there might be water present, or there's a fault with the switch itself.

This error suggests that the pressure switch is reporting the machine is full, potentially due to a blocked drain pump or a faulty switch. The machine may not drain water properly.

This error indicates that the relay controlling the heating element is continuously 'on,' which can lead to overheating or other heating issues. The machine may not heat correctly or could overheat.

This error indicates a heater relay stuck on, similar to F07, but also points to a possible issue with the pressure switch. This can lead to improper heating or water level detection.

This error indicates a problem with the electronic setup or memory (Eeprom) of the machine's main control board. This can prevent the machine from starting or operating correctly.

This error means the pressure switch is not able to detect any water level changes, which can prevent the machine from filling or progressing through its cycle.

This error indicates that the machine is unable to activate the drain pump, which means water cannot be removed from the drum. This will prevent the machine from completing its cycle.

This error indicates a loss of communication between the main electronic control boards within the appliance. This can prevent any functions from working or the machine from starting.

This error indicates a problem with the door locking mechanism, preventing the door from locking or unlocking correctly. The machine will not start if the door isn't securely locked.

This error specifically indicates a communication problem related to the control system for a 3-phase motor. This often points to an issue with the power board.

If the door is not closed securely prior to starting a program, the door lock will make approximately 5 'clunk' noises, and the display will show a flashing 'DOOR' message, accompanied by an audible beep every 5 seconds.

When you try to select an option that is not compatible with the currently chosen wash program, the LED on the option button will flash, and you will hear a bleeping noise. This indicates an invalid selection.