Status LEDs do not flash ON and OFF when activating diagnostic mode — Unsuccessful Entry

What does Incorrect LED flash - Diagnostic Entry mean?

Upon attempting to activate diagnostic test modes, the status LEDs do not flash ON and OFF in half-second intervals as expected, indicating an incorrect entry sequence.

• Diagnostic activation sequence not completed within 6 seconds.
• Rotating the cycle selector knob too fast or too slow during the sequence.

Click steps to track your progress.

1. 1

   Repeat the diagnostic activation sequence carefully, ensuring all steps are completed within the 6-second timeframe.

2. 2

   Pay close attention to the speed and precision of rotating the cycle selector knob during each step of the sequence.

3. 3

   Ensure the washer is in standby mode (plugged in, all indicators off) and wait 10 seconds after initial power is applied before trying again.