Lo FL or F8 E1 / Lo FL or F08 E01 — Water supply error

What does Lo FL or F8 E1 / Lo FL or F08 E01 mean?

The display shows a 'Lo' followed by 'FL' or 'F8 E1' / 'F08 E01', indicating a problem with the water supply to the washer. The unit will drain for 8 minutes with the door locked to reset the code.

• Both hot and cold water inlet hoses are not attached or not properly supplying water.
• Hot and/or cold water faucets are turned off.
• Inlet valve screens on the washer are clogged.
• Inlet hoses are kinked.
• Auto shut-off connectors and hoses (if used) are not properly installed or working.
• Incorrect inlet hoses being used.

Click steps to track your progress.

1. 1

   Check that both hot and cold water faucets are fully turned on.

2. 2

   Ensure both inlet hoses are securely attached to the washer and the water supply, and there are no kinks in the hoses.

3. 3

   Verify the inlet valve screens on the washer are not clogged. Clean if necessary.

4. 4

   Allow the 8-minute drain cycle to complete. Once finished, touch POWER once to clear the code, then touch POWER again to restart the washer.

5. 5

   If the code reappears after following these steps, call for service.