PTO activation does not work

What does PTO activation does not work mean?

The Power Take-Off (PTO) clutch does not engage or activate when commanded. This can prevent attachments from operating and is typically due to electrical issues like a blown fuse, low battery voltage, or wiring problems.

• Blown 5A 'Fuse P.T.O.'.
• Low battery voltage.
• Wiring fault to the PTO clutch or switch.

Click steps to track your progress.

1. 1

   Check and replace the 5A 'Fuse P.T.O.' if it's blown.

2. 2

   Measure the battery voltage on J6 (pin 3) with the key in the 'ON' position; it should match battery voltage. Charge the battery if low.

3. 3

   Inspect the gray cable and connectors from J1 (pin 9) on the control board to the PTO clutch.

4. 4

   Check the blue cable and connectors from the PTO clutch to the battery.

5. 5

   Examine the yellow cables and connectors from J6 (pin 3 and pin 6) on the control board to the PTO switch. Repair or replace any damaged wiring.